General i/o settings – Grass Valley EDIUS v.5.1 User Manual
Page 711
EDIUS — User Reference Guide
711
EDIUS SP/SP-SDI (SHX) Settings
The sync status is displayed in the windows below the Sync Signal button.
Either NO SYNC or SYNC OK will be displayed depending on whether or
not an input reference signal is detected.
5.
If applicable, move the Phase Adjust slider to fine tune the sync signal.
6.
Select “Use Input Sync while capturing” if sync signal is normally off
but you want to use the input sync while capturing.
Note
If “Input Sync" is set as the Sync Signal type and no sync signal is present,
“Off(free run)” is automatically used even though the setting remains at
“Input Sync.” If an input sync source is then supplied, the system will con-
tinue to operate in Off(free run) mode. To force the detection of the sync
source, Click on the Player and then the Recorder in the Preview window.
Switching the active preview window will force the system to recognize the
sync signal and operate in “Input Sync” mode.
7.
Click the
OK
button to save settings and close the SHX-E1/SHX-E2
settings dialog.
While in the SHX-E1/SHX-E2 Settings dialog, clicking the
Default*
button
will return all settings to their default values.
General I/O Settings
1.
If necessary, click the “+” to expand the SHX-E1/SHX-E2 Settings tree.
2.
Select “General I/O Settings” from the SHX-E1/SHX-E2 Settings tree.
The dialog in