Grass Valley EDIUS v.5.1 - Manual (Page 472)

472 EDIUS — User Reference Guide
Section 5 — Timeline Operations
Alternative Method:
1. Click on the switch point you wish to change.
2. Place the mouse cursor in the recorder and rotate the mouse wheel
while holding down the [
SHIFT ] key.
3. Release the [ SHIFT ] key when the switch point is at the desired location.
Note Moving a switch point that is set at the Out point (end) of a clip trims the clip.
Deleting Camera Switch Points
To delete a camera switch point, follow these steps:
1. Position the Timeline cursor at the switch point to be deleted.
2. Right-click the time scale and select “Add Cut Point/Clear Cut Point
(Toggle)” from the menu as shown in
Figure 535 .
Figure 535. Time Scale Menu - Add Cut Point/Clear Cut Point
The camera switch point is deleted. Any clips that were cut at that switch
point location are merged.
Note If a clip was divided by a cut point that is removed and part of the clip was
disabled, the enable/disable setting of the merged clip will be same as the
setting for the first portion of the previously divided clip.
Alternative Methods:
• Right-click the camera switch point to be deleted and select “Delete Cut
Point” from the menu.
• Double-click the camera switch point to be deleted.
• Press the [ 0 ] (Zero) key on the numeric keypad (the number line zero is
not supported).