Grass Valley EDIUS v.5.1 - Manual (Page 403)

EDIUS — User Reference Guide 403
Trimming Clips
Figure 443. Split Trim to Cursor Position from Clip End
Slide Trim
As a clip is trimmed, slide trimming shifts forward or backward the start
and end points of the neighboring clip. The total length of the clips does not
change.
When Ripple mode is On, slide trimming is not allowed if there is no margin between the clip
to be trimmed and adjacent clips. When trimming clips with a margin, trimming can only be
done up to the length of the margin.
To slide trim a clip do the following:
1. Click the border between two clips.
The color of the cut point change to green or yellow and trimming is
enabled. See
Figure 444 .
Note You may also select the slide trim cut point nearest to the Timeline cursor on
the selected track by clicking the Trim - Select Slide button in the Trim
window.
Figure 444. Slide Trim Clip Select