Grass Valley Aurora Ingest v.6.5.2 - Manual (Page 78)

Make sure you have already configured the VTR Controller application before
completing this section. The VTR information in these two applications needs to
match.
1. In the VTR Ingest application, select Tools | Options .
2. In the VTR tab, enter the IP address or host name of the Aurora Ingest - Server.
3. If desired, check the Prompt for Tape ID box.
This feature allows you to customize the identification of your tape. If you don’t
enter a tape ID, VTR Ingest prompts you to enter the ID before you ingest the
first clip.
4. If needed, you can also enable the Auto Scan feature. It allows you to scan and
capture media from a tape according to timecode breaks.
5. Select a channel from the drop-down list and enter the name of the channel.
6. Enter the IP address or name of the computer where VTR Controller is installed.
(If VTR Controller is installed on the same machine, enter localhost .)
78 Aurora Ingest System Guide 13 August2009
Configuring Aurora Ingest