Grass Valley Aurora Ingest v.6.5.2 - Manual (Page 168)

1. Find the spot on the videotape where you want your clip to begin.
2. Mark an In Point using any of the following methods:
• Press I on your keyboard.
• Click the Mark In button on the Aurora Ingest window.
• Type the timecode in the In field.
• Create a Mark In on the VTR.
3. Play through the tape until you reach the point where you want the clip to end.
4. Mark an Out Point using any of these methods:
• Press O on your keyboard.
• Click the Mark Out button on the Aurora Ingest window.
• Use the up or down arrows to find the correct timecode.
• Type the ending timecode in the Out field.
• Create a Mark Out on the VTR.
Recording clips to the media server
After you’ve created a segment (batch) list, you can record the clips to your media
server.
If you want to reserve a channel to record a clip using VTR Ingest, you can ensure this in
Aurora Ingest - Scheduler by using Add VTR Ingest Reservation.
If you are recording to SD channels of K2 version 3.2, you can also set the clip aspect ratio in
the clip record area of VTR Ingest.The option to switch aspect ratio is set in the System tab
168 Aurora Ingest System Guide 13 August2009
Using Aurora Ingest - VTR Ingest