Grass Valley Aurora Ingest v.6.5.2 - Manual (Page 67)

2. Check the Enable X-keys box to activate the X-keys feature.
3. Click the Configure button to start configuring your X-keys.
Some of the X-keys have been pre-configured on the Green layer, mostly with
transport control functions. You can still change the default layout or add new
commands on the unused keys.
NOTE: Before you can use the X-keys Jog/Shuttle controller, you need to
install the X-keys Macro Works software. However, do not use the X-keys
Macro Maker application to modify the keys.
4. To customize a key, click on the key that you want to configure or modify.
A drop-down list displays the available commands.
5. Select a command to apply to this key.
6. Repeat steps 4 and 5 to configure additional keys.
7. Once you have finished configuring those keys, click OK .
In addition to keys, the controller comes with jog/shuttle knob. The jog control, the
center disk of the knob, allows you to make precise frame by frame selections for
editing. The outer rim can be used in Shuttle or Varispeed mode.
13 August2009 Aurora Ingest System Guide 67
Configuring Aurora Ingest