H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 453)

440
b. Click Apply.
4. To disable the non-standard PD detection function of a specified PSE:
a. Select Disable in the corresponding Non-Standard PD Compatibility column of the target PSE.
b. Click Apply.
5. To enable the non-standard PD detection for all PSEs, click Enable All.
6. To disable the non-standard PD detection for all PSEs, click Disable All.
Displaying information about PSE and PoE ports
1. Select PoE > PoE from the navigation tree.
2. On the Summary tab, the upper part displays the PSE summary. To view the configuration and
power information, click a port on the chassis front panel.
Figure 428 PoE summary (with GigabitEthernet 1/0/1 selected)
PoE configuration example
Network requirements
• As shown in Figure 429 , GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 are connected to IP
telephones.
• GigabitEthernet 1/0/11 is connected to AP whose maximum power does not exceed 9000
milliwatts.