H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 190)

177
3. Configure the link aggregation group information as described in Table 56 .
4. Click Apply.
Table 56 Configuration items
Item Description
Enter Link Aggregation
Interface ID Assign an ID to the link aggregation group to be created.
You can view the result in the Summary list box at the bottom of the page.
Specify Interface Type
Set the type of the link aggregation interface to be created:
• Static (LACP Disabled)
• Dynamic (LACP Enabled)
Select port(s) for the link
aggregation interface
Select one or multiple ports to be assigned to the link aggregation group from
the chassis front panel.
You can view the result in the Summary list box at the bottom of the page.
Displaying information of an aggregate interface
1. Select Network > Link Aggregation from the navigation tree.
The Summary tab is displayed by default, as shown in
Figure 159 . The list on the upper part of the
page displays information about all the aggregate interfaces.
2. Select an aggregate interface from the list to display the detailed information about the member
ports of the corresponding link aggregation group on the lower part of the page, as shown
in
Figure 159 .