Lldp basic settings configuration example, Network requirements, Displaying lldp – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 213: Information received, From lldp neighbors
200
Field Description
Device class
The device class advertised by the local device:
•
Connectivity device: An intermediate device that provide network connectivity.
•
Class I: a generic endpoint device. All endpoints that require the discovery
service of LLDP belong to this category.
•
Class II: A media endpoint device. The class II endpoint devices support the
media stream capabilities in addition to the capabilities of generic endpoint
devices.
•
Class III: A communication endpoint device. The class III endpoint devices
directly support end users of the IP communication system. Providing all
capabilities of generic and media endpoint devices, Class III endpoint devices
are used directly by end users.
Displaying LLDP information received from LLDP
neighbors
1.
Select Network > LLDP from the navigation tree.
2.
Click the Neighbor Summary tab to display the global LLDP neighbor information, as shown
in
Figure 174 The Neighbor Summary tab
LLDP basic settings configuration example
Network requirements
As shown in
, a network management station is connected to Switch A over Ethernet and
Switch A is connected to a MED device and Switch B through ports GigabitEthernet 1/0/1 and
GigabitEthernet 1/0/2 respectively.
Configure LLDP on Switch A and Switch B so that the network management station can determine the link
status of Switch A.