H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 258)

245
IPv6 static route configuration example
Network requirements
The IP addresses of devices are shown in Figure 220 . IPv6 static routes need to be configured on Switch
A, Switch B and Switch C for any two hosts to communicate with each other.
Figure 220 Network diagram
Configuration outlines
1. On Switch A, configure a default route with Switch B as the next hop.
2. On Switch B, configure one static route with Switch A as the next hop and the other with Switch C
as the next hop.
3. On Switch C, configure a default route with Switch B as the next hop.
Configuration procedure
1. Configure a default route to Switch B on Switch A:
a. After you log in to the Web interface of Switch A, select Network > IPv6 Routing from the
navigation tree.
b. Click the Create tab.
c. To configure a default route to Switch B on Switch A:
{
Type :: for Destination IP Address.
{
Select 0 from the Prefix Length list.
{
Type 4::2 for Next Hop.
d. Click Apply.
Vlan-int400
2::1/64
Host B 2::2/64
Vlan-int200
4::2/64
Vlan-int300
5::2/64
Vlan-int200
4::1/64
Vlan-int300
5::1/64
Vlan-int500
3::1/64 Vlan-int100
1::1/64
Host A 1::2/64 Host C 3::2/64
Switch B
Switch A Switch C