beautypg.com

Configuring caller group control, Network requirements, Configuration procedure – H3C Technologies H3C MSR 5600 User Manual

Page 86

background image

76

Configuring caller group control

Network requirements

As shown in

Figure 31

, areas A, B, and C call each other through the SIP server. Configure caller group

control on Router A so when the SIP server fails, the areas call each other though the public PBXs in PSTN

as follows:

The phone numbers starting with 1100 in area A can only call the phone numbers in area B.

The phone numbers starting with 1200 in area A can call the phone numbers both in area B and
area C.

Figure 31 Network diagram

Configuration procedure

This example does not provide SIP server and digital voice interface configurations. For related

information, see "Configuring SIP" and "Configuring voice interfaces."

1.

Configure Router A:
# Configure subscriber group 1 that matches calling numbers starting with 1100 and configure
subscriber group 2 that matches calling numbers starting with 1200.

system-view

[RouterA] voice-setup

[RouterA-voice] dial-program

[RouterA-voice-dial] subscriber-group 1

[RouterA-voice-dial-group1] match-template 1100..

[RouterA-voice-dial-group1] quit

[RouterA-voice-dial] subscriber-group 2

[RouterA-voice-dial-group2] match-template 1200..

[RouterA-voice-dial-group2] quit

# Configure VoIP entity 2000 to use the SIP proxy server to find call destination addresses and to

match called numbers in area B.

[RouterA-voice-dial] entity 2000 voip

Router A

Router B

Router C

SIP server

IP

1100..

2100

2200

3100

3200

110000

110099

Internal

PBX

120000

120099

1200..

Public PBX

Public PBX

Internal

PBX

Public PBX

Internal

PBX

Area A

Area B

Area C

E1 1/0

E1 1/0