Configuration procedure, Verifying the configuration, Fxo interface plar configuration example – H3C Technologies H3C MSR 5600 User Manual
Page 32: Network requirements
22
Configure the two routers to enable Telephone B to establish a call with Telephone A through two dials.
Figure 9 Network diagram
Configuration procedure
1.
On Router A, configure the local number as 0101001 for POTS entity 1001, and bind FXS
interface line1/0 to the POTS entity.
[RouterA] voice-setup
[RouterA-voice] dial-program
[RouterA-voice-dial] entity 1001 pots
[RouterA-voice-dial-entity1001] match-template 0101001
[RouterA-voice-dial-entity1001] line 1/0
2.
Configure Router B:
# Configure the called number as 010 for VoIP entity 010, and configure the destination IP
address as 1.1.1.1.
[RouterB] voice-setup
[RouterB-voice] dial-program
[RouterB-voice-dial] entity 010 voip
[RouterB-voice-dial-entity10] match-template 0101001.
[RouterB-voice-dial-entity10] address sip ip 1.1.1.1
[RouterB-voice-dial-entity10] quit
# Configure the local number as 07552001 for POTS entity 2001, and bind FXO interface
line1/0 to POTS entity 2001.
[RouterB-voice-dial] entity 2001 pots
[RouterB-voice-dial-entity2001] match-template 07552001
[RouterB-voice-dial-entity2001] line 1/0
# Configure the number sending mode as all.
[RouterB-voice-dial-entity2001] send-number all
Verifying the configuration
After the user of Telephone B dials 07552003, the user hears a dial tone. Then, the user of Telephone B
dials 0101001, and Telephone A rings. After the user of Telephone A picks up the handset, the two users
can establish a conversation.
FXO interface PLAR configuration example
Network requirements
As shown in
, Router A and Router B are connected through an IP network and can reach each
other. The PBX is configured with a trunk number 07552003.
IP network
Router A
Router B
07552001
FXS 1/0
FXO 1/0
PBX
Telephone B
Eth2/1
2.2.2.2/24
Eth2/1
1.1.1.1/24
Telephone A
0101001