Configuring options related to dial program, Configuring a voip entity, Configuration task list – H3C Technologies H3C MSR 5600 User Manual
Page 66
56
Configuring options related to dial program
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter voice view.
voice-setup
N/A
3.
Enter dial program view.
dial-program
N/A
4.
Create a POTS entity and
enter POTS entity view.
entity entity-number pots N/A
5.
Configure permitted calling
numbers.
caller-permit calling-string
Optional.
By default, the voice entity permits all calling
numbers.
6.
Configure the priority of the
POTS entity.
priority priority-order
Optional.
By default, the priority level is 0.
The smaller the number, the higher the
priority.
7.
Bind a number substitution
rule list to the voice entity.
substitute { called |
calling } list-number
By default, no number substitution rule list is
bound to a voice entity (no number
substitution is performed).
8.
Bind a subscriber group to
the voice entity.
caller-group { deny |
permit } group-id
By default, no subscriber group is bound to
the voice entity (any calling number is
allowed to originate calls).
9.
Configure the number
sending mode.
send-number
{ digit-number | all |
truncate }
By default, the truncate mode is used.
For more information about the above commands, see "Configuring dial programs."
Configuring a VoIP entity
This section covers the procedures for creating and configuring a VoIP entity.
Configuration task list
To configure a VoIP entity, perform the following tasks:
Tasks at a glance
(Required.)
Creating a VoIP entity and configuring basic parameters
(Optional.)
Configuring codecs for a VoIP entity
(Optional.)
Configuring DTMF for a VoIP entity
(Optional.)
Enabling VAD for a VoIP entity
(Optional.)
Configuring options related to dial program