beautypg.com

Verifying the configuration, Bsv dss1 signaling configuration example, Network requirements – H3C Technologies H3C MSR 5600 User Manual

Page 59

background image

49

[RouterB] interface GigabitEthernet 0/0

[RouterB-GigabitEthernet0/0] ip address 2.2.2.2 255.255.255.0

[RouterB-GigabitEthernet0/0] quit

# Bundle the timeslots on interface E1 5/0 into a PRI set.

[RouterB] controller e1 5/0

[RouterB-E1 5/0] pri-set

[RouterB-E1 5/0] quit

# Configure the local number 07552001 for POTS entity 2001, and bind the digital voice
interfaces line 5/0:15 to the POTS entity.

[RouterB] voice-setup

[RouterB-voice] dial-program

[RouterB-voice-dial] entity 2001 pots

[RouterB-voice-dial-entity2001] match-template 07552001

[RouterB-voice-dial-entity2001] line 5/0:15

[RouterB-voice-dial-entity2001] send-number all

[RouterB-voice-dial-entity2001] quit

# Configure the local number 07552002 for POTS entity 2002, and bind the digital voice

interfaces line 5/0:15 to the POTS entity.

[RouterB-voice-dial] entity 2002 pots

[RouterB-voice-dial-entity2002] match-template 07552002

[RouterB-voice-dial-entity2002] line 5/0:15

[RouterB-voice-dial-entity2002] send-number all

[RouterB-voice-dial-entity2002] quit

# Configure the called number template 010…. for VoIP entity 010, and configure the destination
IP address as 1.1.1.1.

[RouterB-voice-dial] entity 010 voip

[RouterB-voice-dial-entity10] match-template 010....

[RouterB-voice-dial-entity10] address ip 1.1.1.1

Verifying the configuration

The telephones can call each other through DSS1 signaling. You can use the display voice

subscriber-line command to view information about digital voice interfaces.

BSV DSS1 signaling configuration example

Network requirements

As shown in

Figure 21

, the routers connect to the PBXs through BSV interfaces.

Configure DSS1 signaling on the routers so the telephones can call each other.