Configuring a busy tone standard, Customizing busy tone parameters, Configuring automatic busy tone detection – H3C Technologies H3C MSR 5600 User Manual
Page 17: Figure 1
7
Figure 1 Busy tone detection
You can configure busy tone detection by customizing busy tone parameters or configuring automatic
busy tone detection. If the tone that the router receives from the PBX matches the busy tone parameters,
the router considers the tone as a busy tone and shuts down the FXO interface.
Configuring a busy tone standard
Two busy tone standards are available: European standard and North American standard. After you
specify a standard, the device uses a set of parameters compliant with that standard for busy tone
detection. If the actual busy tone data do not completely match the set of parameters, the device can use
customized busy tone parameters or automatic busy tone detection to accurately detect busy tones.
To configure a busy tone standard:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter voice view.
voice-setup N/A
3.
Specify a busy tone standard.
area { europe |
north-america }
By default, the European
standard is used.
Customizing busy tone parameters
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter voice view.
voice-setup
N/A
3.
Customize busy tone
parameters.
busytone-detect custom
area-number index argu f1 f2 p1
p2 p3 p4 p5 p6 p7
N/A
4.
Enable using customized busy
tone parameters.
area custom
By default, the European standard
is used.
This command takes effect on all
FXO interfaces on the device.
The customized busy tone
parameters take effect only after
you configure this command.
Configuring automatic busy tone detection
Figure 2 Automatic busy tone detection
As shown in
, the process of automatic busy tone detection is as follows:
1.
Telephone A establishes a call to Telephone B.