H3C Technologies H3C MSR 5600 - Manual (Page 24)

14
Figure 5 Wink start
To configure the immediate start mode:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter E&M interface view. subscriber-line line-number N/A
3. Configure the immediate start
mode for the E&M interface.
signal immediate
The default is the immediate start
mode.
4. Configure a delay the
originating side waits to send
DTMF tones in immediate start
mode.
delay send-dtmf milliseconds
The default is 300 milliseconds.
Use this command on the
originating device.
To configure the delay start mode:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter voice interface view. subscriber-line line-number N/A
3. Configure the delay start mode for the
E&M interface.
signal delay
The default is the immediate
start mode.
4. Configure the seizure signal duration in
delay start mode.
delay hold milliseconds
The default is 400 milliseconds.
Use this command on the
terminating device.
5. Configure the delay time from when the
terminating side detects a seizure
signal to when it sends the seizure
signal in delay start mode.
delay rising milliseconds
The default is 300 milliseconds.
Use this command on the
terminating device.
To configure the wink start mode:
Step Command Remarks
1. Enter system view. system-view N/A