H3C Technologies H3C MSR 5600 - Manual (Page 14)

4
• To ensure correct call time, make sure the router system time transmitted in data-message format
stays synchronous with the local standard time.
• For the CID function to operate correctly, keep the cid send command enabled.
Configuration procedure
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter FXS interface view. subscriber-line line-number N/A
3. (Optional.) Configure the
calling name for the FXS
interface.
calling-name text
By default, no calling name is configured.
The calling name can be sent only in the
multiple-data-message format.
Use this command on the originating
device.
4. Enable the FXS interface
to send CID to the remote
end. cid send
Optional.
By default, this function is enabled.
Use this command on the originating
device.
5. Configure the standard
mode for sending CID.
cid standard-type { bellcore |
brazil }
By default, the bellcore mode is used.
This command is for use on the
terminating device, which encapsulates
the CID by using the configured standard
mode and sends it to the called
telephone.
The message format configured by using
the cid type command takes effect only
when the bellcore mode is used.
6. Configure the data
message format.
cid type { complex | simple }
The default is complex.
Use this command on the terminating
device.
When the originating device supports
only one message format, you must use
that message format on the terminating
device.
7. Enable CID on the FXS
interface.
cid display
By default, CID is enabled.
Use this command on the terminating
device.
Setting the electrical impedance
The electrical impedance setting must be subject to country specifications. Each country corresponds to
an impedance value. You specify an impedance value while specifying a country.
To set the electrical impedance:
Step Command Remarks
1. Enter system view. system-view N/A