H3C Technologies H3C MSR 5600 - Manual (Page 76)

66
[RouterB-voice-dial-entity2000] line 1/0
[RouterB-voice-dial-entity2000] quit
[RouterB-voice-dial] entity2001 pots
[RouterB-voice-dial-entity2001] match-template 200012341234$
[RouterB-voice-dial-entity2001] line 1/1
After you dial number 20001234 at Telephone A, the number matches VoIP entity 2000 and
Telephone B rings because the device uses shortest match mode by default.
Configuring longest match
# Configure the longest match mode on Router A.
[RouterA-voice-dial] number-match longest
After you dial number 20001234 at Telephone A and waits for a period of time, the number matches
VoIP entity 2000 and Telephone B rings. If you dial 1234 during the waiting period (the dialed number
is 200012341234), the number matches VoIP entity 2001 and Telephone C rings.
Configuring a terminator
# Configure the terminator # on Router A.
[RouterA-voice-dial] terminator #
After you dial 20001234# at Telephone A, the number immediately matches VoIP entity 2000 and
Telephone B rings.
Configuring the maximum number of total calls
allowed by a voice entity
You can limit the maximum number of total calls (both incoming and outgoing) allowed by a voice entity.
The device stops establishing new calls when the limit is reached.
To configure the maximum number of total calls allowed:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter voice view. voice-setup N/A
3. Enter dial program view. dial-program N/A
4. Enter voice entity view. entity entity-number { pots | voip } N/A
5. Configure the maximum
number of total calls allowed
by the voice entity. max-conn max-number
By default, no maximum number of
total calls is configured.
Configuring number substitution
A number substitution rule replaces a matching number with another number. You can configure number
substation rules and then apply these rules globally or to voice entities.
A number substitution process is as follows: