beautypg.com

Verifying the configuration, E1 dss1 signaling configuration example, Network requirements – H3C Technologies H3C MSR 5600 User Manual

Page 57

background image

47

[RouterB-GigabitEthernet0/0] quit

# Create a timeslot set on interface E1 5/0.

[RouterB] controller e1 5/0

[RouterB-E1 5/0] timeslot-set 1 timeslot-list 1-31 signal r2

[RouterB-E1 5/0] quit

# Configure the local number 07552001 for POTS entity 2001, and bind the digital voice
interfaces line 5/0:1 to the POTS entity.

[RouterB] voice-setup

[RouterB-voice] dial-program

[RouterB-voice-dial] entity 2001 pots

[RouterB-voice-dial-entity2001] match-template 07552001

[RouterB-voice-dial-entity2001] line 5/0:1

[RouterB-voice-dial-entity2001] send-number all

[RouterB-voice-dial-entity2001] quit

# Configure the local number 07552002 for POTS entity 2002, and bind the digital voice

interfaces line 5/0:1 to the POTS entity.

[RouterB-voice-dial] entity 2002 pots

[RouterB-voice-dial-entity2002] match-template 07552002

[RouterB-voice-dial-entity2002] line 5/0:1

[RouterB-voice-dial-entity2002] send-number all

[RouterB-voice-dial-entity2002] quit

# Configure the called number template 010…. for VoIP entity 010, and configure the destination

IP address as 1.1.1.1.

[RouterB-voice-dial] entity 010 voip

[RouterB-voice-dial-entity10] match-template 010....

[RouterB-voice-dial-entity10] address ip 1.1.1.1

Verifying the configuration

The telephones can call each other through R2 signaling. You can use the display voice subscriber-line

command to view information about digital voice interfaces.

E1 DSS1 signaling configuration example

Network requirements

As shown in

Figure 21

, the routers connect to the PBXs through E1 interfaces.

Configure DSS1 signaling on the routers so the telephones can call each other.