Configuration procedure – H3C Technologies H3C MSR 5600 User Manual
Page 118
108
Figure 44 Network diagram
Configuration procedure
Before performing the following configuration, make sure Router A, Router B and Router C can reach
each other.
1.
Configure Router A:
# Create VoIP entity 2000, configure the destination IP address as 10.1.1.2, and configure the
called number as 2000.
[RouterA] voice-setup
[RouterA-voice] dial-program
[RouterA-voice-dial] entity 2000 voip
[RouterA-voice-dial-entity2000] address sip ip 10.1.1.2
[RouterA-voice-dial-entity2000] match-template 2000
[RouterA-voice-dial-entity2000] quit
# Configure the local number as 1000 for POTS entity 1000, and bind FXS interface line 1/0 to
the POTS entity.
[RouterA-voice-dial] entity 1000 pots
[RouterA-voice-dial-entity1000] line 1/0
[RouterA-voice-dial-entity1000] match-template 1000
2.
Configure Router B:
# Create VoIP entity 3000, configure the destination IP address as 20.1.1.2, and configure the
number template as 3000.
[RouterB] voice-setup
[RouterB-voice] dial-program
[RouterB-voice-dial] entity 3000 voip
[RouterB-voice-dial-entity3000] address sip ip 20.1.1.2
[RouterB-voice-dial-entity3000] match-template 3000
[RouterB-voice-dial-entity3000] quit
# Configure the local number as 2000 for POTS entity 2000, and bind FXS interface line 1/0 to
the POTS entity.
[RouterB-voice-dial] entity 2000 pots
[RouterB-voice-dial-entity2000] line 1/0
[RouterB-voice-dial-entity2000] match-template 2000
# Configure call forwarding.
1000
Eth1/1
10.1.1.1/24
3000
Router A
Eth1/1
20.1.1.2/24
2000
Eth1/2
10.1.1.2/24
Eth1/1
20.1.1.1/24
Router B
Router C
Telephone B
Telephone C
Telephone A