beautypg.com

Enabling vad for a voip entity, Configuring options related to dial program – H3C Technologies H3C MSR 5600 User Manual

Page 69

background image

59

Step Command

Remarks

5.

Configure out-of-band DTMF .

(Method 1) Configure NTE
mode:

{

Enable NTE mode:
outband nte

{

Configure the value of the
payload type used by NTE:

rtp payload-type nte value

(Method 2) Configure SIP

mode:

outband sip

Use either method.
By default, inband transmission is
adopted, and the value of the

payload type used by NTE is 101.
When the device is connected to a

device from another vendor, you
cannot set the payload type field to

any value forbidden by that

device. Otherwise, an NTE

negotiation failure might occur.

Enabling VAD for a VoIP entity

The voice activity detection (VAD) discriminates between silence and speech on a voice connection
according to their energies. With VAD, a POTS entity does not generate traffic during periods of silence

in an active voice connection.
To enable VAD:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter voice view.

voice-setup

N/A

3.

Enter dial program view.

dial-program

N/A

4.

Create a VoIP entity and enter

VoIP entity view.

entity entity-number voip

N/A

5.

Enable VAD.

vad-on [ g723r53 | g723r63 |
g729a | g729r8 ] *

By default, VAD is disabled.
The G.711 and G.726 codecs do

not support VAD. The G.729br8
codec always supports VAD.

Configuring options related to dial program

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter voice view.

voice-setup

N/A

3.

Enter dial program view.

dial-program

N/A

4.

Create a VoIP entity and

enter VoIP entity view.

entity entity-number voip N/A

5.

(Optional.) Configure the
permitted calling numbers.

caller-permit calling-string

Optional.
By default, the voice entity permits all calling

numbers.