beautypg.com

Verifying the configuration, E&m non-signaling mode configuration example, Network requirements – H3C Technologies H3C MSR 5600 User Manual

Page 35: Configuration procedure

background image

25

# Enter the view of E&M interface 5/0. The E&M interface must have the same configuration as the

connected PBX.

system-view

[RouterB] subscriber-line 5/0

# Configure the wink start mode.

[RouterB-subscriber-line5/0] signal wink

# Configure the 4-wire cable type (optional, because the default is the 4-wire cable type).

[RouterB-subscriber-line5/0] cable 4-wire

# Configure the signal type as 5 (optional, because the default is 5).

[RouterB-subscriber-line5/0] type 5

Verifying the configuration

After the user of Telephone A dials 07552001, Telephone B rings. When the user of Telephone B picks

up the handset, the two users can establish a conversation.
After the user of Telephone B dials 0101001, Telephone A rings. When the user of Telephone A picks up

the handset, the two users can establish a conversation.

E&M non-signaling mode configuration example

Network requirements

As shown in

Figure 12

, configure the PLAR mode for the E&M interface on Router A. When the user of

Telephone A dials picks up the handset, the E&M interface automatically calls Telephone B.

Figure 12 Network diagram

Configuration procedure

1.

Configure Router A:
# Configure the called number as 2000 for VoIP entity 2000, and configure the destination IP
address as 2.2.2.2.

system-view

[RouterA] voice-setup

[RouterA-voice] dial-program

[RouterA-voice-dial] entity 2000 voip

[RouterA-voice-dial-entity2000] match-template 2000

[RouterA-voice-dial-entity2000] address sip ip 2.2.2.2

[RouterA-voice-dial-entity2000] quit

# Configure the local number as 1000 for POTS entity 1000, and bind E&M interface line 5/0 to

the POTS entity.