beautypg.com

Configuring the packet loss compensation mode, Configuring an fxs interface to send lcfo signals – H3C Technologies H3C MSR 5600 User Manual

Page 15

background image

5

Step Command

Remarks

2.

Enter FXS interface view.

subscriber-line line-number N/A

3.

Set the electrical impedance
of a country.

impedance { country-name | r550
| r600 | r650 | r700 | r750 |

r800 | r850 | r900 | r950 }

The default is the electrical
impedance of China.
You must configure the same
electrical impedance value on the

originating and terminating

devices.

Configuring the packet loss compensation mode

You can configure the packet loss compensation mode to alleviate the impact of packet loss on voice

quality:

For discrete packet loss, you can use the general compensation mode to reconstruct lost packets.

For continuous packet loss, you can use the voice gateway-specific compensation mode to
compensate for lost packets.

To configure the packet loss compensation mode:

Step Command

Remarks

1.

Enter system view.

System-view

N/A

2.

Enter FXS interface view.

subscriber-line line-number N/A

3.

Configure the packet loss
compensation mode for the

FXS interface.

plc-mode { general | specific }

By default, the specific algorithm
provided by the voice gateway is

used for an FXS interface.

Configuring an FXS interface to send LCFO signals

You can configure an FXS interface to send a loop current feed open (LCFO) signal when the peer goes

on-hook. This function is used mainly in North America.
To configure an FXS interface to send LCFO signals:

Step Command

Remarks

1.

Enter system view.

System-view

N/A

2.

Enter FXS interface view.

subscriber-line line-number N/A

3.

Configure the FXS interface to

send an LCFO signal when the
peer goes on-hook.

disconnect lcfo

By default, no LCFO signal is sent
(a busy tone is played to the peer

end).

4.

Set the duration of the LCFO
signal.

timer disconnect-pulse value

The default is 750 milliseconds.