H3C Technologies H3C S10500 Series Switches - Manual (Page 90)

75
OSPF configuration task list
Make a proper plan before configuring OSPF.
To run OSPF in a routing domain, you must first enable OSPF on the routers. Then use the default settings
of parameters such as the hello interval, LSA delay timer, and SPF calculation interval. You can also
configure them as needed. OSPF routers should be configured on an area basis. Wrong configurations
may cause communication failures, routing information blocks, and routing loops.
Complete the following tasks to configure OSPF:
Task Remarks
Enabling OSPF Required
Configuring a stub area
Configuring an NSSA area Configuring OSPF areas
Configuring a virtual link
Optional
Configuring the OSPF network type for an interface as
broadcast
Optional
Configuring the OSPF network type for an interface as NBMA Optional
Configuring the OSPF network type for an interface as P2MP Optional
Configuring OSPF
network types
Configuring the OSPF network type for an interface as P2P Optional
Configuring OSPF route summarization Optional
Configuring OSPF inbound route filtering Optional
Configuring ABR Type-3 LSA filtering Optional
Configuring an OSPF cost for an interface Optional
Configuring the maximum number of OSPF routes Optional
Configuring the maximum number of load-balanced routes Optional
Configuring OSPF preference Optional
Configuring OSPF route
control
Configuring OSPF route redistribution Optional
Configuring OSPF packet timers Optional
Specifying LSA transmission delay Optional
Specifying SPF calculation interval Optional
Specifying the LSA arrival interval Optional
Specifying the LSA generation interval Optional
Disabling interfaces from receiving and sending OSPF
packets
Optional
Configuring stub routers Optional
Configuring OSPF authentication Optional
Adding the interface MTU into DD packets Optional
Configuring the maximum number of external LSAs in LSDB Optional
Tuning and optimizing
OSPF networks
Enabling compatibility with RFC 1583 Optional