H3C Technologies H3C S10500 Series Switches - Manual (Page 285)

270
Configuring a RIPng route filtering policy
Reference a configured IPv6 ACL or prefix list to filter received or advertised routing information. You can
also filter outbound routes redistributed from a routing specific routing protocol.
Follow these steps to configure a RIPng route filtering policy:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIPng view ripng [ process-id ] ––
Configure a filter policy to filter
incoming routes
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
import
Required
By default, RIPng does not filter
incoming routing information.
Configure a filter policy to filter
outgoing routes
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ protocol [ process-id ] ]
Required
By default, RIPng does not filter
outgoing routing information.
Configuring a priority for RIPng
Any routing protocol has its own protocol priority used for optimal route selection. You can set a priority
for RIPng manually. The smaller the value, the higher the priority.
Follow these steps to configure a RIPng priority:
To do… Use the command… Remarks
Enter system view system-view —
Enter RIPng view ripng [ process-id ] —
Configure a RIPng priority
preference [ route-policy
route-policy-name ] preference
Optional
By default, the RIPng priority is
100.
Configuring RIPng route redistribution
Follow these steps to configure RIPng route redistribution:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIPng view ripng [ process-id ] ––
Configure a default routing metric
for redistributed routes
default cost cost
Optional
The default metric of redistributed
routes is 0.
Redistribute routes from another
routing protocol
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
Required
No route redistribution is
configured by default.