H3C Technologies H3C S10500 Series Switches - Manual (Page 349)

334
To do… Use the command… Remarks
Enter IPv6 address family view ipv6-family —
Specify keepalive
interval and holdtime timer keepalive keepalive hold
holdtime
Configure
IPv6 BGP
timers
Configure keepalive
interval and holdtime for
an IPv6 peer or peer
group
peer { ipv6-group-name |
ipv6-address } timer keepalive
keepalive hold holdtime
Optional
The keepalive interval defaults to
60 seconds, holdtime defaults to
180 seconds.
Configure the interval for sending the
same update to an IPv6 peer or peer
group
peer { ipv6-group-name |
ipv6-address }
route-update-interval interval
Optional
The interval for sending the same
update to an iBGP peer or an
eBGP peer defaults to 15
seconds or 30 seconds.
NOTE:
•
Timers configured using the timer command have lower priority than timers configured using the peer
timer command.
• The holdtime interval must be at least three times the keepalive interval.
Configuring IPv6 BGP soft reset
Enable route refresh
Follow these steps to enable route refresh:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter IPv6 address family
view
ipv6-family —
Enable route refresh
peer { ipv6-group-name | ipv6-address }
capability-advertise route-refresh Optional
Enabled by default.
Perform manual soft-reset
Follow these steps to perform manual soft reset:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter IPv6 address family view ipv6-family —
Save all routes from an IPv6 peer
or peer group, not letting them go
through the inbound policy
peer { ipv6-group-name | ipv6-address }
keep-all-routes Optional
Not saved by default.