H3C Technologies H3C S10500 Series Switches - Manual (Page 378)

363
Routing Tables
Routing for Network
Destination Cost Type NextHop AdvRouter Area
192.168.1.0/24 1 Transit 192.168.1.1 192.168.1.1 0.0.0.0
Routing for ASEs
Destination Cost Type Tag NextHop AdvRouter
172.17.1.0/24 100 Type2 1 192.168.1.2 192.168.2.2
172.17.2.0/24 1 Type2 20 192.168.1.2 192.168.2.2
172.17.3.0/24 1 Type2 1 192.168.1.2 192.168.2.2
192.168.2.0/24 1 Type2 1 192.168.1.2 192.168.2.2
Total Nets: 5
Intra Area: 1 Inter Area: 0 ASE: 4 NSSA: 0
Applying a routing policy to IPv6 route redistribution
Network requirements
As shown in Figure 117 :
• Enable RIPng on Switch A and Switch B.
• On Switch A, configure three static routes, and apply a routing policy to static route redistribution
to permit routes 20::0/32 and 40::0/32, and deny route 30::0/32.
• Display RIPng routing table information on Switch B to verify the configuration.
Figure 117 Network diagram for routing policy application to route redistribution
Configuration procedure
1. Configure Switch A.
# Configure IPv6 addresses for VLAN-interface 100 and VLAN-interface 200.
system-view
[SwitchA] ipv6
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ipv6 address 10::1 32
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] ipv6 address 11::1 32
[SwitchA-Vlan-interface200] quit
# Enable RIPng on VLAN-interface 100.
[SwitchA] interface vlan-interface 100