Logging ipv6 peer or peer group state changes, Controlling route distribution and reception, Configuration prerequisites – H3C Technologies H3C S10500 Series Switches User Manual
Page 342: Configuring ipv6 bgp route redistribution
327
To do…
Use the command…
Remarks
Enter IPv6 address family view
ipv6-family
—
Disable session establishment to an IPv6
peer or peer group
peer { ipv6-group-name |
ipv6-address } ignore
Optional
Not disabled by default
Logging IPv6 peer or peer group state changes
Follow these steps to configure to log on the session and event information of an IPv6 peer or peer group:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enable logging of peer changes
globally
log-peer-change
Optional
Enabled by default.
Enter IPv6 address family view
ipv6-family
—
Enable the state change logging
for an IPv6 peer or peer group
peer { ipv6-group-name |
ipv6-address } log-change
Optional
Enabled by default.
NOTE:
See
Layer 3—IP Routing Command Reference for information about the log-peer-change command.
Controlling route distribution and reception
This task includes routing information filtering, routing policy application, and route dampening.
Configuration prerequisites
•
Enable IPv6
•
Configure IPv6 BGP basic functions
Configuring IPv6 BGP route redistribution
Follow these steps to configure IPv6 BGP route redistribution:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv6 address family view
ipv6-family
—
Enable default route redistribution into the
IPv6 BGP routing table
default-route imported
Optional
Not enabled by
default.