H3C Technologies H3C S10500 Series Switches - Manual (Page 343)

328
To do… Use the command… Remarks
Enable route redistribution from another
routing protocol
import-route protocol [ process-id [ med
med-value | route-policy route-policy-name ]
* ] Required
Not enabled by
default.
NOTE:
If the default-route imported command is not configured, using the import-route command cannot
redistribute any IGP default route.
Configuring IPv6 BGP route summarization
To reduce the routing table size on medium and large BGP networks, configure route summarization on
BGP routers. BGP supports only manual summarization of IPv6 routes.
Follow these steps to configure IPv6 BGP route summarization:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter IPv6 address family
view
ipv6-family —
Configure manual route
summarization
aggregate ipv6-address prefix-length [ as-set |
attribute-policy route-policy-name |
detail-suppressed | origin-policy route-policy-name
| suppress-policy route-policy-name ] *
Required
Not configured by
default.
Advertising a default route to an IPv6 peer or peer group
Follow these steps to advertise a default route to an IPv6 peer or peer group:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter IPv6 address family view ipv6-family —
Advertise a default route to an
IPv6 peer or peer group
peer { ipv6-group-name | ipv6-address }
default-route-advertise [ route-policy
route-policy-name ]
Required
Not advertised by
default.
NOTE:
With the peer default-route-advertise command executed, the local router advertises a default route with
itself as the next hop to the specified IPv6 peer or peer group, regardless of whether the default route is
available in the routing table.
Configuring outbound route filtering
Follow these steps to configure outbound route filtering: