Configuration procedure – H3C Technologies H3C S10500 Series Switches User Manual

Page 316

301

Figure 108 Network diagram for OSPFv3 route redistribution

Configuration procedure

Configure IPv6 addresses for interfaces. (Details not shown)

Configure OSPFv3 basic functions.

# Enable OSPFv3 process 1 on Switch A.

system-view

[SwitchA] ipv6

[SwitchA] ospfv3 1

[SwitchA-ospfv3-1] router-id 1.1.1.1

[SwitchA-ospfv3-1] quit

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] ospfv3 1 area 2

[SwitchA-Vlan-interface100] quit

[SwitchA] interface vlan-interface 200

[SwitchA-Vlan-interface200] ospfv3 1 area 2

[SwitchA-Vlan-interface200] quit

# Enable OSPFv3 process 1 and OSPFv3 process 2 on Switch B.

system-view

[SwitchB] ipv6

[SwitchB] ospfv3 1

[SwitchB-ospfv3-1] router-id 2.2.2.2

[SwitchB-ospfv3-1] quit

[SwitchB] interface vlan-interface 100

[SwitchB-Vlan-interface100] ospfv3 1 area 2

[SwitchB-Vlan-interface100] quit

[SwitchB] ospfv3 2

[SwitchB-ospfv3-2] router-id 3.3.3.3

[SwitchB-ospfv3-2] quit

[SwitchB] interface vlan-interface 300

[SwitchB-Vlan-interface300] ospfv3 2 area 2

[SwitchB-Vlan-interface300] quit

# Enable OSPFv3 process 2 on Switch C.

system-view

[SwitchC] ipv6

[SwitchC] ospfv3 2

[SwitchC-ospfv3-2] router-id 4.4.4.4

[SwitchC-ospfv3-2] quit

This manual is related to the following products: