H3C Technologies H3C S10500 Series Switches - Manual (Page 53)

38
To do… Use the command… Remarks
Specify a RIP neighbor peer ip-address
Required
By default, RIP does not unicast
updates to any peer.
Enter interface view
interface interface-type
interface-number
—
Enable BFD on the RIP interface rip bfd enable
Required
Disabled by default
NOTE:
•
Unidirectional detection in BFD echo packet mode only works for RIP neighbors that are directly
connected (one hop away from each other).
• Using the undo peer command does not remove the neighbor relationship at once; therefore, it cannot
bring down the BFD session at once.
Displaying and maintaining RIP
To do… Use the command… Remarks
Display RIP current status and
configuration information
display rip [ process-id |
vpn-instance vpn-instance-name ]
[ | { begin | exclude | include }
regular-expression ]
Display all active routes in RIP
database
display rip process-id database [ |
{ begin | exclude | include }
regular-expression ]
Display RIP interface information
display rip process-id interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Display routing information about
a specified RIP process
display rip process-id route
[ ip-address { mask | mask-length }
| peer ip-address | statistics ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Reset a RIP process reset rip process-id process
Clear the statistics of a RIP process reset rip process-id statistics
Available in user view
RIP configuration examples
Configuring RIP version
Network requirements
As shown in Figure 10 , enable RIPv2 on all interfaces on Switch A and Switch B.