H3C Technologies H3C S10500 Series Switches - Manual (Page 173)

158
2. Specify the LSP refresh interval and generation interval
Each router needs to refresh LSPs generated by itself at a configurable interval and send them to other
routers to prevent valid routes from being aged out. A smaller refresh interval speeds up network
convergence but consumes more bandwidth.
When the network topology changes, for example, a neighbor is down or up, or the interface metric,
system ID, or area ID is changed, the router generates an LSP after a configurable interval. If such a
change occurs frequently, excessive LSPs are generated, consuming a large amount of router resources
and bandwidth. To solve the problem, you can adjust the LSP generation interval.
Follow these steps to specify the LSP refresh interval and generation interval:
To do… Use the command… Remarks
Enter system view system-view —
Enter IS-IS view isis [ process-id ] [ vpn-instance vpn-instance-name ] —
Specify the LSP refresh interval timer lsp-refresh seconds
Optional
900 seconds by
default
Specify the LSP generation
interval
timer lsp-generation maximum-interval
[ initial-interval [ second-wait-interval ] ] [ level-1 |
level-2 ]
Optional
2 seconds by default
3. Specify LSP sending intervals
If a change occurs in the LSDB, IS-IS advertises the changed LSP to neighbors. You can specify the
minimum interval for sending such LSPs.
On a P2P link, IS-IS requires an advertised LSP be acknowledged. If no acknowledgement is received
within a configurable interval, IS-IS will retransmit the LSP.
Follow these steps to configure LSP sending intervals:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Specify the minimum interval for
sending LSPs and the maximum LSP
number that can be sent at a time
isis timer lsp time [ count count ]
Optional
By default, the minimum interval is 33
milliseconds, and the maximum LSP
number that can be sent at a time is 5.
Specify the LSP retransmission
interval on a P2P link
isis timer retransmit seconds
Optional
5 seconds by default
NOTE:
Configure a proper LSP retransmission interval to avoid unnecessary retransmissions.
Specifying LSP lengths
IS-IS messages cannot be fragmented at the IP layer because they are directly encapsulated in frames.
IS-IS routers in an area must send LSPs smaller than the smallest interface MTU in this area.