H3C Technologies H3C S10500 Series Switches User Manual
Page 363
348
5.
Configure BFD parameters (you can use default BFD parameters instead).
# Configure Switch A.
[SwitchA] bfd session init-mode active
[SwitchA] interface vlan-interface 100
•
Configure the minimum interval for transmitting BFD control packets as 500 milliseconds.
[SwitchA-Vlan-interface100] bfd min-transmit-interval 500
•
Configure the minimum interval for receiving BFD control packets as 500 milliseconds.
[SwitchA-Vlan-interface100] bfd min-receive-interval 500
•
Configure the detect multiplier as 7.
[SwitchA-Vlan-interface100] bfd detect-multiplier 7
[SwitchA-Vlan-interface100] quit
# Configure Switch C.
[SwitchC] bfd session init-mode active
[SwitchC] interface vlan-interface 101
•
Configure the minimum interval for transmitting BFD control packets as 500 milliseconds.
[SwitchC-Vlan-interface101] bfd min-transmit-interval 500
•
Configure the minimum interval for receiving BFD control packets as 500 milliseconds.
[SwitchC-Vlan-interface101] bfd min-receive-interval 500
•
Configure the detect multiplier as 7.
[SwitchC-Vlan-interface101] bfd detect-multiplier 7
[SwitchC-Vlan-interface101] return
6.
Verify the configuration.
The following operations are made on Switch C. Operations on Switch A and Switch B are similar and
are not shown.
# Display detailed BFD session information.
Total session number: 1 Up session number: 1 Init mode: Active
IPv6 Session working under Ctrl mode:
Local Discr: 17 Remote Discr: 13
Source IP: 3001::3
Destination IP: 3000::1
Session State: Up Interface: Vlan-interface101
Min Trans Inter: 500ms Act Trans Inter: 500ms
Min Recv Inter: 500ms Act Detect Inter: 3000ms
Recv Pkt Num: 57 Send Pkt Num: 53
Hold Time: 2200ms Connect Type: Direct
Running Up for: 00:00:06 Auth mode: none
Protocol: BGP6
Diag Info: No Diagnostic
The output shows that a BFD session is established between Switch A’s VLAN-interface 100 and Switch
C’s VLAN-interface 101 and that BFD runs properly.