H3C Technologies H3C S10500 Series Switches - Manual (Page 100)

85
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure an OSPF cost for
the interface
ospf cost value
Optional
The default cost depends on the interface
type: 1 for a VLAN interface; 0 for a
loopback interface; computed according
to the bandwidth for other interfaces.
Follow these steps to configure a bandwidth reference value:
To do… Use the command… Remarks
Enter system view system-view —
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
—
Configure a bandwidth
reference value
bandwidth-reference value
Optional
The value defaults to 100
Mbps.
Configuring the maximum number of OSPF routes
Follow these steps to configure the maximum number of routes:
To do… Use the command… Remarks
Enter system view system-view —
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
—
Configure the maximum number of
OSPF routes maximum-routes { external | inter | intra }
number
Optional
The number varies with
devices.
Configuring the maximum number of load-balanced routes
If several equal-cost routes to the same destination are available, you can configure them as
load-balanced routes to improve link utilization.
Follow these steps to configure the maximum number of load-balanced routes:
To do… Use the command… Remarks
Enter system view system-view —
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
—
Configure the maximum number of
load-balanced routes
maximum load-balancing maximum
Optional
8 by default