H3C Technologies H3C S10500 Series Switches - Manual (Page 138)

123
Configure OSPF on the switches, ensuring that Switch S, Switch A, and Switch B can communicate with
each other at Layer 3 and dynamic route update can be implemented among them with OSPF. (Details
not shown)
2. Configure OSPF NSR.
# Enable OSPF NSR on Switch S.
system-view
[SwitchS] ospf non-stop-routing
3. Verify the configuration.
After Switch S establishes neighbor relationships with Switch A and Switch B, they start to exchange
routing information. After network convergence, perform an active/standby switchover on Switch S.
During the switchover period, use the display ospf peer command to check the neighbor relationship
between Switch A and Switch S and between Switch B and Switch S; use the display ospf routing
command to check if there are routes from Switch A to the loopback interface on Switch B and from
Switch B to the loopback interface on Switch A.
# When an active/standby switchover occurs on Switch S, display OSPF neighbors and routes on Switch
A.
display ospf peer
OSPF Process 1 with Router ID 192.168.1.40
Neighbor Brief Information
Area: 0.0.0.0
Router ID Address Pri Dead-Time Interface State
192.168.1.41 12.12.12.2 1 40 Vlan100 Full/BDR
display ospf routing
OSPF Process 1 with Router ID 192.168.1.40
Routing Tables
Routing for Network
Destination Cost Type NextHop AdvRouter Area
44.44.44.44/32 2 Stub 12.12.12.2 44.44.44.44 0.0.0.0
14.14.14.0/24 2 Transit 12.12.12.2 192.168.1.41 0.0.0.0
22.22.22.22/32 0 Stub 22.22.22.22 192.168.1.40 0.0.0.0
12.12.12.0/24 1 Transit 12.12.12.1 192.168.1.40 0.0.0.0
Total Nets: 4
Intra Area: 4 Inter Area: 0 ASE: 0 NSSA: 0
# Display OSPF neighbors and routes on Switch B.
display ospf peer
OSPF Process 1 with Router ID 44.44.44.44
Neighbor Brief Information
Area: 0.0.0.0
Router ID Address Pri Dead-Time Interface State
192.168.1.41 14.14.14.2 1 33 Vlan200 Full/DR