H3C Technologies H3C S10500 Series Switches - Manual (Page 339)

324
Task Remarks
Configuring BFD for IPv6 BGP Optional
Configuring IPv6 BGP basic functions
Configuration prerequisites
Before configuring IPv6 BGP basic functions, complete the following tasks:
• Specify IP addresses for interfaces
• Enable IPv6
NOTE:
Create a peer group before configuring basic functions for it. For related information, see “ Configuring
IPv6 BGP peer group .”
Specifying an IPv6 BGP peer
Follow these steps to configure an IPv6 BGP peer:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Specify a router ID router-id router-id
Optional
Required if no IP addresses are
configured for any interfaces.
Enter IPv6 address family view ipv6-family —
Specify an IPv6 peer
peer ipv6-address as-number
as-number
Required
Injecting a local IPv6 route
Follow these steps to configure advertise a local route into the routing table:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter IPv6 address family view ipv6-family —
Inject a local route into the IPv6
BGP routing table
network ipv6-address prefix-length
[ short-cut | route-policy
route-policy-name ]
Required
Not added by default