ARAG Bravo 400S Seletron - Manual (Page 99)

99
"JOB MENU" - F8 MENU
15.8
F8 Menu
Job settings menu

1

2
Fig. 336
1 In the guidance screen, press Menu .
2 Press F8 to view the Settings menu (Fig. 337).
Fig. 337
In this screen it is possible to access
several different menus, which can be
useful during spraying:
•
Alarms (par. 10.1.11).
• Working parameters (par. 10.1.12).
• Device status (par. 10.5).
15.8.1 Speed source
Fig. 338
Allows to select the source for speed calculation. Available options:
• GPS
Information concerning speed is received by the GPS, which is connected directly to Bravo 400S.
• Wheel sensor
When this option is enabled, the speed is calculated on the basis of the pulses received by the
speed sensor installed on the wheel.
WARNING: guidance information and all accessory functions
(surface calculation, alignment, etc.) are disabled.
The wheel constant must be entered during the setup procedure (par. 10.1.8).
• GPS and Wheel sensor
When this option is enabled, Bravo 400S uses both sources:
- The guidance information and the accessory functions are active thanks to the data sent by the
GPS receiver.
- The output is adjusted (par. 13.1) according to the speed read by the wheel sensor.
• Simulation
Allows to enable speed simulation in order to carry out adjustment tests even when the machine is stationary.
SIMULATION
SPEED


Fig. 339
Edit simulation speed (DEF 6.0 km/h - 3.7 MPH):
F3 ( + ) increases, F5 ( - ) decreases
WARNING: guidance information and all accessory functions
(surface calculation, alignment, etc.) are disabled.
Par.
7.4
Exit the function or
data change Confirm access
or data change Scroll
(LEFT / RIGHT)
Delete
selected
character Increase /
decrease
value
Scroll
(UP / DOWN)
Enter
selected
character