ARAG Bravo 400S Seletron - Manual (Page 73)

73
13.7 Boom section management
AUTOMATIC MANAGEMENT ON AUTOMATIC MANAGEMENT OFF (MANUAL)
The section valves are closed or opened automatically. Section valves must be opened or closed manually.
To change section valve management mode, use function F6 Automatic section control ON/OFF (par. 13.8).
TREATMENT AND BOOM SECTION STATUS
Main control OFF
Sections OFF
Main control OFF
Sections ON
Section ON Section OFF Zone to be sprayed
OPEN SECTION
Zone already sprayed
CLOSE SECTION
OPENING AND CLOSING SIGNALS
MANUAL MANAGEMENT OF THE SPRAYING POINTS
When the overlapping exceeds the value set for the Sections overlapping limit (par. 10.1.12), Bravo 400S warns that the relevant spraying points must be
CLOSED (Fig. 246). Close the valves through the relevant switches: Bravo 400S will confirm closing on display.
As the machine advances, the signal is triggered for each valve.
When overlapping returns within the set limit, Bravo 400S warns to OPEN the relevant spraying points (Fig. 247). Open the valves through the relevant switches: Bravo
400S will confirm opening on display. As the machine advances, the signal is triggered for each valve.
Closing signal Opening signal
Fig. 246 Fig. 247
AUTOMATIC MANAGEMENT OF THE SPRAYING POINTS
When overlapping of ONE or MORE spraying points is above the set value for the Sections overlapping limit (par. 10.1.12) Bravo 400S CLOSES the relevant
valves (Fig. 248). It is not necessary to intervene on the switches.
Bravo 400S closes the sections automatically. Job interruption is shown on the display in real time.
When overlapping returns within the set limit, Bravo 400S opens the relevant valves automatically. Job resumption is shown on the display in real time (Fig. 249).
Automatic section closing Automatic section opening
Fig. 248 Fig. 249
"AUTOMATIC FUNCTIONS" - F6 AUTOMATIC SECTION CONTROL ON/OFF