ARAG Bravo 400S Seletron - Manual (Page 42)

42
10.1.13 Device calibration
Fig. 137
Allows to start calibration for the devices connected to Bravo 400S.
SELETRON SYSTEM
• Identification numbers reset
Fig. 138 Fig. 139
Allows to reset the identification numbers of all
saved Seletrons, before repeating the pairing
procedure (cap. 11).
- Select Identification numbers reset
(Fig. 138) and press OK .
- The message in Fig. 139 is displayed: confirm
reset by pressing
OK again.
At the end of the reset procedure,
DISCONNECT ALL SELETRONS and start a
new pairing procedure (chap. 11).
SENSORS
• Tank level zero value
Fig. 140
In the cases below it is necessary to perform the level sensor zero adjustment.
1 Bravo 400S displays the presence of fluid inside the tank, even when it is empty.
2 A tank profile has been loaded (par. 10.1.10).
To use this menu the level sensor must be active ( Tank level source , chap. 9). Perform the
adjustment with empty tank.
Fig. 141 Fig. 142
1 Select the item Tank level zero value
(Fig. 140) and press OK .
2 The message in Fig. 141 is displayed: follow
the instructions, then start the procedure by
pressing
OK .
3 Press OK to reset the level sensor residual
signal.
Value out of range!
If this alarm is displayed, faulty values have
been detected: check the sensor operation.
If problem persists, check for residual fluid
in the tank.
ADVANCED SETTINGS "IMPLEMENT"
Par.
7.4
Exit the function or
data change Confirm access
or data change Scroll
(LEFT / RIGHT)
Delete
selected
character Increase /
decrease
value
Scroll
(UP / DOWN)
Enter
selected
character