ARAG Bravo 400S Seletron - Manual (Page 32)

32
10.1.7 Nozzles data
Legend:
A Nozzle
B Reference rate
C Reference pressure
A B C
Fig. 91 Fig. 92
Allows setting the values of 12 types of ISO
nozzles and 6 "User" nozzles (A, B, C, D, E, F).
The values for Flowrate and
Pressure can be modified for "User"
nozzles ONLY, not for "ISO" nozzles.
- Select the nozzle you wish to set up (Fig. 91).
- Enter the relevant features (Fig. 92).
- If necessary, repeat the setup for each nozzle.
Fig. 93 Fig. 94
• Flowrate
• Pressure
Set the reference flowrate and pressure for the
selected nozzle.
The rate of the nozzle being used allows
Bravo 400S to calculate the pressure without a
pressure sensor.
Fig. 95 Fig. 96
• Minimum pressure
• Maximum pressure
Set the pressure limits for the selected nozzle.
Enable the relevant function on the
Alarms
menu (par. 10.1.11) if you want the computer to
trigger an alarm when the nozzle is outside the
set range.
For the procedure to be followed when an
alarm occurs, please refer to par. 17.1 Error
messages.
Pressure limits for the nozzle in use
allow Bravo 400S to select the
suitable nozzle during spraying,
therefore they must be set correctly.
ADVANCED SETTINGS "IMPLEMENT"
Par.
7.4
Exit the function or
data change Confirm access
or data change Scroll
(LEFT / RIGHT)
Delete
selected
character Increase /
decrease
value
Scroll
(UP / DOWN)
Enter
selected
character