ARAG Bravo 400S Seletron - Manual (Page 67)

67
12.5 Spraying a field
Let us assume we want to spray a field
along parallel lines, but only once the
edges of the field have been sprayed.
Fig. 224
• Go the beginning of the field to be sprayed.
• Switch Bravo 400S on (par 7.2).
After self-diagnostics, Bravo 400S displays the "Home"
screen (Fig. 224).
• Begin a new job, using the function F3 New job
(par. 14.3).
• Enter spraying settings.
SPRAYING SETTINGS
Fig. 225
Fig. 226
Target rate
- Set the spray rate value for the treatment (Fig. 226).
Press
OK to confirm the value.
Fig. 227
Fig. 228
Select nozzles config
- Select a nozzle configuration from the list (Fig. 228).
With this data indicate which nozzles are installed on the boom
spraying points (preset configurations in the
Spray spots
configuration menu, par. 10.1.1).
- Press OK to confirm.
Fig. 229
Fig. 230
Map
If there is at least one map (on the internal memory), you can select
a prescription map for the spraying.
According to the position detected by the GPS receiver, Bravo 400S
will use the appropriate spray rate for the area that is being sprayed
(par. 13.3 Importing and using a prescription map).
- Select a map from the list (Fig. 230).
- Press
OK to confirm.
Fig. 231
Mark A ?
Fig. 232
Job Start
- Select and press OK to switch to guidance.
Fig. 233
• In the job menu, set the tank level with the function F3 Tank (par. 15.3).
• Start spraying by acting on the main control valve switch.
• Start moving along the field perimeter.
USE