Implement rear view, Advanced settings "implement – ARAG Bravo 400S Seletron User Manual
Page 46
46
*
Fig. 159
Fig. 160
• Implement rear view
- Confirm by pressing
OK
to enter setup.
- Enter the value.
*
Implement width
Implement width
Boom width
(sprayed area)
14.00 m
20.00 m
Fig. 161
The width set for the implement is shown on the display in the guidance screen: usually it is
equal to the boom width, and thus to the covered area diagram.
If you wish to see two different widths displayed on the guidance screen, as in the example
of Fig. 161, set the
Implement width
to a different value than the boom width
(par. 10.1.2).
END 10.1.14 3-point implement geometry settings (SYSTEM WITH REAR / FRONT 3-POINT HITCH)
> > > 10.1.14 3-point implement geometry settings (SYSTEM WITH REAR / FRONT 3-POINT HITCH)
ADVANCED SETTINGS
"IMPLEMENT"
Par.
Exit the function or
data change
Confirm access
or data change
Scroll
(LEFT / RIGHT)
Delete
selected
character
Increase /
decrease
value
Scroll
(UP / DOWN)
Enter
selected
character