ARAG Bravo 400S Seletron User Manual
ARAG GPS receiver
Table of contents
Document Outline
- 1 Risks and protections before assembly
- 2 Intended use
- 3 Precautions
- 4 Package content
- 5 Position on farming machine
- 6 Wiring connections
- 6.1 General precautions for a correct harness position
- 6.2 Switch panel connection
- 6.3 Connecting the Remote Control Units (RCU) (Seletron RCU and hydraulic RCU)
- 6.4 Securing the Seletron cables
- 6.5 Hydraulic valve connection
- 6.6 Sensor connection
- 6.7 Camera connection
- 6.8 Power supply connection
- 6.9 SD memory card
- 6.10 Pendrive
- 7 Setup
- 8 Menu structure
- 9 Basic settings
- 10 Advanced setup
- 10.1 Implement
- 10.1.1 Spray spots configuration
- 10.1.2 Boom settings
- SECTION MANAGEMENT
- 10.1.3 Flowmeter
- 10.1.4 Filling flowmeter
- 10.1.5 Pressure sensor
- 10.1.6 Valves
- MAIN VALVE
- PRESSURE REGULATING VALVE
- SECTION VALVES
- 10.1.7 Nozzles data
- 10.1.8 Wheel sensor
- 10.1.9 Rev counter
- 10.1.10 Tank
- 10.1.11 Alarms
- NOZZLES ALARMS
- FLOWMETER ALARMS
- REV COUNTER ALARMS
- 10.1.12 Working parameters
- SPRAYING LIMITS
- AUTOMATIC SECTION CONTROL
- GUIDANCE
- 10.1.13 Device calibration
- SELETRON SYSTEM
- SENSORS
- 10.1.14 3-point implement geometry settings (SYSTEM WITH REAR / FRONT 3-POINT HITCH)
- 10.1.15 Towed implement geometry settings (SYSTEM WITH TOWING HITCH)
- 10.2 Tractor
- 10.3 User
- 10.4 General options
- 10.5 Device status
- 10.1 Implement
- 11 Seletron connection
- 12 Use
- 13 Automatic functions
- 13.1 Output adjustment
- 13.2 F2 Automatic adjustment ON/OFF
- 13.3 Importing and using a prescription map
- 13.4 How the automatic nozzle selection works (SELETRON system)
- 13.5 F4 Automatic nozzle selection ON/OFF
- 13.6 F1/F3/F5/F7 Manual nozzle selection
- 13.7 Boom section management
- 13.8 F6 Automatic section control ON/OFF
- 14 "Home" Menu
- 15 Job menu
- 16 Job functions
- 17 Maintenance / diagnostics / repairs
- 18 Technical data
- 19 End-of-life disposal
- 20 Guarantee terms