ARAG Bravo 400S Seletron - Manual (Page 88)

88
14.5
F5 Resume job
Enables procedure for resuming a previously saved job.
1 Press F5 to resume a previous job, from the list of saved jobs.
As for the New job function (par. 14.3), if the current job has not been saved yet, Bravo 400S will prompt the user to save it.
2 Select the job among those in the list (Fig. 306) and press OK to confirm the selection.
2a When an "old" job is resumed, Bravo 400S provides guidance information by restoring the conditions which were active at the time of saving.
If the
Loading options screen is enabled (see par. 10.3.6), it is possible to choose which information to load (Fig. 307).
3 Check the Spraying settings in Fig. 308; modify them if necessary.
4 Select and press OK to switch to guidance mode.
5 Complete the job (Fig. 309).

1

2
Fig. 306
Fig. 307
2a

In this screen it is possible to enable or disable the information memorized during the last saving
(
Value enabled, Value disabled).
- Select, one by one, the parameters shown in the list and start the setup procedure:
• Applied area disabling this parameter resets the relevant counter.
• Perimeter disabling this parameter resets the calculated surface counter.
• Reference lines
• Points of interest (POI)
• Job data disabling this parameter resets all counters;
upon job loading a new spraying start date and time will be saved.
- Select Start job... and press OK to switch to Spraying settings .
Fig. 308
3
5
Fig. 309

4
"HOME" MENU - F5 RESUME JOB
Par.
7.4
Exit the function or
data change Confirm access
or data change Scroll
(LEFT / RIGHT)
Delete
selected
character Increase /
decrease
value
Scroll
(UP / DOWN)
Enter
selected
character