ARAG Bravo 400S Seletron - Manual (Page 65)

65
USE
12.2.1 "Buffer Zone" function enabled
Some spraying procedures include areas called "Buffer zones" where spraying must be reduced or absent.
In addition to the standard nozzles used, it is necessary to install special nozzles (e.g.: ASJ AOC) which reduce the spray or the drift on boom ends.
Fig. 221 Buffer zone Buffer zone
Enable this function from the implement basic settings (chap. 9) to select either the standard nozzles or the special ones.
• LH special nozzle enabling (Boom from behind)
Press the switch once to the left to enable the nozzle for the LH "Buffer zone" and close the standard one. The LH LED blinks.
• RH special nozzle enabling (Boom from behind)
Press the switch once to the right to enable the nozzle for the RH "Buffer zone" and close the standard one. The RH LED blinks.
• LH special nozzle disabling (Boom from behind)
Press the switch once to the right to disable the nozzle for the LH "Buffer zone" and enable the standard one. The LH LED does not blink and
stays on.
• RH special nozzle disabling (Boom from behind)
Press the switch once to the left to disable the nozzle for the RH "Buffer zone" and enable the standard one. The RH LED does not blink and
stays on.
12.3 Operating switches for hydraulic valves
Release
of the boom height
Block
of the boom height
Leveling
of the boom height
clockwise
Leveling
of the boom height
counter-clockwise
Increase
of the boom height
Decrease
of the boom height
Boom section
movement:
opening
Boom section
movement: closing