Westermo ID-90 - Manual (Page 98)

98 6607-2204
Table 6 CAPI causes and their explanation
Coding of the CAPI cause in hexadecimal form.
0000 No error
0001NCPI ignored
0002
Flags ignored
0003 Alert already sent
1001 Too many applications
1002 Logical block size too small
1003 Buffer exceeds 64k
1004 Message buffer size too small
1005 Too many logical connections
1006 Reserved1
1007 Message could not be accepted
1008 Register OS Resource Error
100a External Equipment not supported
100b External Equipment only
1101 Bad application ID
1102 Illegal cmd or message length
1103 Message queue full
1104 Message queue empty
1105 Message lost
1106 Unknown notification
1107 Message not accepted
1108 OS Resource Error
1109 CAPI not installed
X.25 causes in Clear packet
Coding of the field “cause” in packet “Indicate-Cause”.
00
DTE/CONF Triggered by the remote DTE/DCE
01 OCC Remote DCE busy, dialled number busy/engaged
03 INV Facility requested not valid/supported
05 NC Temporary disturbance in network
09 DER Remote DTE doesn´t answer/out of operation
0B NA Access not available
0D NP No access with this dial number
11 RPE Remote procedural error, sequence error
13 ERR Local procedural error, sequence error
19 RNA Reverse charging not accepted
21 ID Remote DTE/DCE imcompatible
29 FNA Incompatible connection request; receipt of single
packet not agreed upon
X.25 causes in Restart packet
Coding of the field “Reason for Restart” in the packet “Indicate-Restart”.
01 Local sequence error
03 Temporarily disturbance in the network
07 Network ready