Westermo ID-90 - Manual (Page 75)

75 6607-2204
cmlp – Multilink PPP control
Call bumping: control of the second B channel connection with multlink PPP protocol.
When set, any incoming voice call will automatically drop one B channel connection if a
multilink PPP session is active. The second B channel of the Multilink session will not be
established after voice connection is released.
0: no call bumping (default)
1: call bumping for incoming voice calls
conntime – Connection timer
The functionality connected to the ”conntime” command does a periodic check every
10:th second to see if there is only a D-channel without a B-channel connected, if that is
the case then the unit waits for another time period specified by the ”conntime” command
(in seconds) before it checks again if the same faulty state is present, if true then the unit
resets, else it returns to the periodic 10 second monitor routine.
Example: conntime=30 (default)
conntime=60
dabort – Dial abort
Dialling will normally be aborted by characters coming from the DTE, by setting parame-
ter dial =0 characters received during the dial procedure will be ignored.
0: Dialling will not be aborted by incoming characters.
1: Characters from DTE aborts dial during the connection process (default).
dbits – Asynchronous databits
Number of data bits asynchronous chars (default: 8) 7, 8
defa – Default settings
Sets up factory default parameter setting.
defa 0: setup all parameter concerning data port
defa 1: setup all parameter including ISDN protocol and msn settings.
dte – B channel link address
Selects the Layer 2 link addresses for ISDN B channel. Only valid for protocols that are
HDLC based (X.75, LAPB).
0 Calling side reacts as DTE,
called side reacts as DCE (default, X.75 standard)
1 TA reacts as DTE (own adr = 01)
3 TA reacts as DCE (own adr = 03)
Note: The value will be changed by setting the B channel protocol (prot).