Flc – flowcontrol, Hlc – higher layer compability, Help – Westermo ID-90 User Manual
Page 76: Idle – idle data timeout, K – windowsize, Lcgr – logical group number x.25, Llc – low layer compatibility, Load – load stored parameter setting, Loadsw – load dip-switches parameter setting

76
6607-2204
flc – Flowcontrol
Flowcontrol to DTE
0: No flowcontrol
3: Hardware flowcontrol RTS/CTS (default)
4: Software flowcontrol XON/XOFF
hlc – Higher layer compability
Higher layer compatibility for outgoing call.
(see note 2 page 85)
help
Displays help texts for all commands
idle – Idle data timeout
Timer to disconnect the ISDN B channel connection after inactivity.
0: inactive (default)
1..n: delay time to disconnect in seconds (1..255).
isdn – ISDN D channel protocol (note 1, page 85)
Selects ISDN D channel protocol
0: DSS1 (Euro-ISDN)
8: VN4 (French)
k – Windowsize
Layer-2 protocol: windowsize (default:7). k = {1..7}
Value will be automatically changed with changing B channel protocol prot.
lcgr – Logical group number X.25
Logical group number for X.25 packet layer protocol.
lcgr = {0..255}, default: 0
llc – Low layer compatibility
Low layer compatibility for outgoing calls (Hex bytes)
(see note 2 and 3, page 85)
load – Load stored parameter setting
All parameters stored in non volatile ram will be loaded.
loadsw – load DIP-switches parameter setting
Parameters entered via the DIP-switches will be loaded and active the same way as if a
power on was exexuted.