Dte – set b channel layer 2 address, Isdn – select d channel protocol, K – set layer 2 windowsize – Westermo ID-90 User Manual

Page 39: Rpwd – password remote configuration, Cmd> – execute configuration command

6607-2204

**DTE – Set B channel Layer 2 address

Selects the Layer 2 link addresses. Only valid for protocols that are HDLC based
(X.75, LAPB).

AT**DTE=0 Calling side reacts as DTE,

called side reacts as DCE (default, X.75 standard)

AT**DTE=1 ID-90 reacts as DTE (own adr = 01)
AT**DTE=3 ID-90 reacts as DCE (own adr = 03)

Note: The value will be changed by setting the B channel protocol (ATBx).

**ISDN – Select D channel protocol

Selects ISDN D channel protocol to the ISDN line. The protocol must fit the protocol run-
ning on the ISDN line otherwise a connection cannot be set up.

Note: after changing and storing the ISDN protocol the ID-90 has to be resetted by

powering it off and on.

AT**ISDN=0

Select DSS1 (Euro-ISDN) (default)

AT**ISDN=8

Select VN4 (France)

**K – Set Layer 2 windowsize

Sets windowsize x layer 2 protocol B channel:

x = 1 ..7, default: 7

AT**k=x

The default value is dependent of the selected B channel protocol.

**RPWD – Password remote configuration

Sets password for remote configuration to nn (1..32 chars)

AT**RPWD=nn

Default: empty.

** – Execute configuration command

Executes one configuration command, for definition of commands see TA+Configurator
commands section.

AT**