Westermo ID-90 - Manual (Page 46)

46 6607-2204
AT result codes
Table 2
Result codes (numerical and verbose):
Short Long Form Description Note
Form
0 OK A command line has been executed.
1 CONNECT Connection established
(rn = call number of remote site)
2 RING Indicates an incoming call (SETUP received)
3 NO CARRIER No synchronization (xx = ISDN error cause)
or if the the call was to and analogue destination
Replaces BUSY and NO DIALTON dependant
on ATXn setting.
Also sent when the modem auto-disconnects due
to loss of carrier.
4 ERROR Illegal command or error that can not be
indicated otherwise e.g.
1.The command line contains a syntax error.
2.The modem cannot execute a command
contained in the command line, i.e., the command
does not exist or is not supported. see register S93
3.A command parameter within the command
line is outside the permitted range.
5 CONNECT 1 200 A connected with a line speed of 1200 bit/s has
been established.
(V110 or analogue connection)
6 NO DIALTONE No access to ISDN network (xx = ISDN error)
7 BUSY Number engaged (xx = ISDN error cause)
8 NO ANSWER No connection; called number can not be reached
(xx = ISDN error cause) or if the the call was to
and analogue destination
The modem is attempting to originate a call if a
continuous ringback signal is detected on the line
until the expiration of the timer S7.
9 CONNECT 600 Connection, line speed 600 bit/s. 1
10 CONNECT 2 400 Connection, line speed 2 400 bit/s.
(V110 or analogue connection)
11 CONNECT 4 800 Connection, line speed 4 800 bit/s.
(V110 or analogue connection)
12 CONNECT 9 600 Connection, line speed 9 600 bit/s.
(V110 or analogue connection)
13 CONNECT 7 200 Connection, line speed 7 200 bit/s. 1
14 CONNECT 12 000 Connection, line speed 12 000 bit/s. 1
15 CONNECT 14 400 Connection, line speed 14 400 bit/s. 1
16 CONNECT 19 200 Connection, line speed 19 200 bit/s.
(V110 or analogue connection)
1
19 CONNECT 64 000 Connection, line speed 64 000 bit/s.